MQSeries.net :: View topic

BretHillier · Posted: Wed Aug 22, 2012 11:38 pm Post subject:

Hi everyone,

For peace of mind I would be grateful if someone could read the following and point out if I am missing anything or further documentaton I need to read.

I need to set up a user to have read-only type access to a couple of broker environments (v 6.1)

For the UNIX based environments, I understand this is best done by Groups. So the procedure would be to:

1. Create a new group brkrviewer
2. Add user to this group
3. Create ACL entries as follows:

mqsicreateaclentry <Config Mgr Name> -g brkrviewer-a -x V
mqsicreateaclentry <Config Mgr Name> -g brkrviewer-a -x V -b <Broker Name>

Then for each execution group:

mqsicreateaclentry <Config Mgr Name> -g brkrviewer-a -x V -b <Broker Name> -e <Broker Name>\<Execution Group Name>

4. Restart the Config Manager

For Windows environment - same procedure but done by user not group?

Lastly, without a Confguration Manager how can read-only/view access to broker and its components be achieved?

Unfortunately I am on Windows 7 so I can't try out these steps with Broker v6.1

Thanks,
Bret.