| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| Validation on MQInput Node |
« View previous topic :: View next topic » |
| Author |
Message
|
| Gideon |
 Posted: Thu Jan 28, 2010 11:09 am Post subject: Validation on MQInput Node |
 |
|
Chevalier
Joined: 18 Aug 2009
Posts: 403
|
I am reading the Info Center on Validation on Input nodes.
I am using WMB 7.
In the doc it discusses the Input Message Parsing, and the Validation sections of the MQInput Node.
It appears (but does not explicitly state) that if I set the the Message Domain to "XMLNSC" and the Message Set to the appropriate Set, and then set Validate to "Content and Value", the incoming XML message will be validated from the XSD upon which the Message set was created. Is taht correct ?
Also, If I set the Message Domain to "XMLNS" without a message set defined, and then set Validate to "Content and Value", exactly how would it validate the message ?
Thanks |
|
| Back to top |
|
 |
| mqjeff |
| Posted: Thu Jan 28, 2010 11:32 am Post subject: |
|
|
Grand Master
Joined: 25 Jun 2008
Posts: 17447
|
This straightforward to answer yourself with the application of basic logic.
Without a message set or an XSD of some kind, what validation of an XML document is possible? |
|
| Back to top |
|
|
| WMBDEV1 |
| Posted: Thu Jan 28, 2010 12:31 pm Post subject: Re: Validation on MQInput Node |
|
|
Sentinel
Joined: 05 Mar 2009
Posts: 888
Location: UK
|
| Gideon wrote: |
Also, If I set the Message Domain to "XMLNS" without a message set defined, and then set Validate to "Content and Value", exactly how would it validate the message ?
|
It addition to MQJeffs comments, XMLNS is none validating anyway and so even with a message set it wouldnt do what you wanted. XMLNSC should be your choice going forward. |
|
| Back to top |
|
|
| kimbert |
| Posted: Thu Jan 28, 2010 2:41 pm Post subject: |
|
|
Jedi Council
Joined: 29 Jul 2003
Posts: 5542
Location: Southampton
|
| Quote: |
| It appears (but does not explicitly state) that if I set the the Message Domain to "XMLNSC" and the Message Set to the appropriate Set, and then set Validate to "Content and Value", the incoming XML message will be validated from the XSD upon which the Message set was created. Is taht correct ? |
Where did you look? I looked up the information on the XMLNSC parser, and immediately found that exact point stated very clearly ( seemed clear to me anyway - I guess we all read things differently) .
Maybe you were only looking at the info on the MQInput node? |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
