| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| DFSYPRX0/DFSYDRU0 |
« View previous topic :: View next topic » |
| Author |
Message
|
| LuisFer |
 Posted: Mon Jun 28, 2004 12:43 pm Post subject: DFSYPRX0/DFSYDRU0 |
 |
|
Partisan
Joined: 17 Aug 2002
Posts: 302
|
| Be careful with this IMS exits & V531 ,the OTMA not suport MQMD V2 (read PQ70706). The Symptom is the msg grows 40 Bytes (the MQMDE).Regards |
|
| Back to top |
|
 |
| Pumpkin |
| Posted: Thu Apr 21, 2005 2:04 am Post subject: |
|
|
Newbie
Joined: 21 Apr 2005
Posts: 1
|
Thanks for the tip.
I am trying to implement the IMS bridge with MQ v5.3 and IMS v5.
For inbound messages to IMS, I can invoke certain transactions but the acknowledgement that I receive contains the tran code, mfs followed by garbage. I need to know, what exactly should I expect from the acknowledgement.
For outbound messages I am still unable to trigger any transactions. I am not sure if it is my exit that is wrong (I copied it from the manual). Do you have any ideas?
All advice and help highly appreciated. |
|
| Back to top |
|
|
| LuisFer |
| Posted: Thu Apr 21, 2005 3:32 am Post subject: |
|
|
Partisan
Joined: 17 Aug 2002
Posts: 302
|
I think that the problem is not on the PRX/DRU IMS exits.
Most common problems with the Brigde are:
1.- Is mandatory a DEAD.QUEUE on the QMgr, if not ,the OTMA brigde will stop.
2.- Security definitions for OTMA.
3.- IIH build , remember LLZZ.
4.-Review the CSQ6SYSP macro (the OTMACON parameter)
Normally the samples IMS exits works fine if you don't have specials requeriments.
Hope this one help you.
Regards |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
