MQSeries.net :: View topic - WMB installation by local user and access by domain user

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » WMB installation by local user and access by domain user

WMB installation by local user and access by domain user

« View previous topic :: View next topic »

Author

Message

aggarwal.intouch

Posted: Wed Jun 25, 2014 10:13 pm Post subject: WMB installation by local user and access by domain user

Acolyte

Joined: 30 May 2011
Posts: 56
Location: India

Hi Techie's,

I have installed WMB v7.0 & WMQ by creating a local user on my machine. Now I want to use both WMB & WMQ using my domain user.

Just want to understand that which all services or components needs to be changed for this?

I tried adding this local user in MQM, admin, mqbrks groups. But while I'm trying to start my broker and queue manager using domain user it is not getting started. I am getting following exception again and again:

"The Queue Manager ended for reason 545284208"

Appreciate your suggestions.

smdavies99

Posted: Wed Jun 25, 2014 11:28 pm Post subject:

Jedi Council

Joined: 10 Feb 2003
Posts: 6076
Location: Somewhere over the Rainbow this side of Never-never land.

You need to read the sections of the WMQ Installation manual about installing WMQ Into a Domain. you need to create a DOmain user with special rights for the WMQ Service to run under.

There are many, many posts in the WMQ Installation & Configuration section of this forum that also discuss problems that people have encountered in this process. (some even have my name on them!)
_________________
WMQ User since 1999
MQSI/WBI/WMB/'Thingy' User since 2002
Linux user since 1995

Every time you reinvent the wheel the more square it gets (anon). If in doubt think and investigate before you ask silly questions.

aggarwal.intouch

Posted: Thu Jun 26, 2014 2:54 am Post subject:

Acolyte

Joined: 30 May 2011
Posts: 56
Location: India

Issue resolved thanks.

Solution : Re-installed MQ

smdavies99

Posted: Thu Jun 26, 2014 3:52 am Post subject:

Jedi Council

Joined: 10 Feb 2003
Posts: 6076
Location: Somewhere over the Rainbow this side of Never-never land.

You re-instaled WMQ when you didn't need to.

The 'Prepare WMQ Wizard' would have done all the bits with the Domain User that you needed to.
The re-installatino would have called that anyway...

_________________
WMQ User since 1999
MQSI/WBI/WMB/'Thingy' User since 2002
Linux user since 1995

Every time you reinvent the wheel the more square it gets (anon). If in doubt think and investigate before you ask silly questions.

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » WMB installation by local user and access by domain user

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP