MQSeries.net :: View topic - broker connection file for multi-instance brokers

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » broker connection file for multi-instance brokers

broker connection file for multi-instance brokers

« View previous topic :: View next topic »

Author

Message

sudaltsov

Posted: Thu Dec 05, 2013 4:53 am Post subject: broker connection file for multi-instance brokers

Voyager

Joined: 02 May 2012
Posts: 82

I was trying to find the definition of the broker configuration file in order to specify multiple instances. For single instance, it is simple like that:

<?xml version="1.0" encoding="UTF-8"?>
<configmgr crlNameList="" domainName="" host="myhost" listenerPort="1414" queueManager="myqm" securityExit="" securityExitJar="" sslCipherSuite="NONE" sslDistinguishedNames="" sslKeyStore="" sslTrustStore="" svrconn="SYSTEM.BKR.CONFIG"/>

How do I specify second host, listenerPort ?

smdavies99

Posted: Thu Dec 05, 2013 6:18 am Post subject:

Jedi Council

Joined: 10 Feb 2003
Posts: 6076
Location: Somewhere over the Rainbow this side of Never-never land.

Are the two brokers running in an Active/Passive HA configuration?
In most cases there is an IP Address associated with the 'service' where the broker is running. connect to that and you should be good to go. You could add a DNS name to the IP addy but there is sometimes a delay in the route being reset so I tend to use the IP address all the time.
_________________
WMQ User since 1999
MQSI/WBI/WMB/'Thingy' User since 2002
Linux user since 1995

Every time you reinvent the wheel the more square it gets (anon). If in doubt think and investigate before you ask silly questions.

Simbu

Posted: Thu Dec 05, 2013 6:20 am Post subject:

Master

Joined: 17 Jun 2011
Posts: 289
Location: Tamil Nadu, India

you may have to visit this RFE request.

http://www.ibm.com/developerworks/rfe/execute?use_case=viewRfe&CR_ID=41536

sudaltsov

Posted: Thu Dec 05, 2013 6:21 am Post subject:

Voyager

Joined: 02 May 2012
Posts: 82

In our case we have 2 addresses, 2 dns names

sudaltsov

Posted: Thu Dec 05, 2013 6:53 am Post subject:

Voyager

Joined: 02 May 2012
Posts: 82

Simbu wrote:

you may have to visit this RFE request.

http://www.ibm.com/developerworks/rfe/execute?use_case=viewRfe&CR_ID=41536

Thank you! That answers my question.

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » broker connection file for multi-instance brokers

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP