| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| Commnad Server running with queue disabled |
« View previous topic :: View next topic » |
| Author |
Message
|
| Tdak |
 Posted: Wed Nov 27, 2013 9:45 am Post subject: Commnad Server running with queue disabled |
 |
|
Novice
Joined: 30 Jun 2008
Posts: 18
Location: South Africa
|
Hi,
I'm upgrading MQ from 7.1 to 7.5 on AIX 7 and there's a total of 20 queue managers on it which I've managed to backup objects of 19 of them except for one where it takes a while to come back and I end up getting the following when I try to back it up:
Requesting attributes of the queue manager...
(mqutils.c) No reply msg, make sure command server is started (strmqcsv qmgr-name)
(saveqmgr.c) -z flag specified but target qmgr is wrong platform or < v6, flag is ignored
and when I check the status of the command server it says
WebSphere MQ command server status . . : Running with queue disabled
Any assistance would be appreciated.
Regards
Tdak |
|
| Back to top |
|
 |
| gbaddeley |
| Posted: Wed Nov 27, 2013 2:14 pm Post subject: |
|
|
Jedi Knight
Joined: 25 Mar 2003
Posts: 2538
Location: Melbourne, Australia
|
Enable the command queue?
_________________
Glenn |
|
| Back to top |
|
|
| bruce2359 |
| Posted: Wed Nov 27, 2013 2:28 pm Post subject: |
|
|
Poobah
Joined: 05 Jan 2008
Posts: 9469
Location: US: west coast, almost. Otherwise, enroute.
|
SYSTEM.COMMAND.INPUT, if memory serves.
_________________
I like deadlines. I like to wave as they pass by.
ב''ה
Lex Orandi, Lex Credendi, Lex Vivendi. As we Worship, So we Believe, So we Live. |
|
| Back to top |
|
|
| mqjeff |
| Posted: Sat Nov 30, 2013 11:58 am Post subject: |
|
|
Grand Master
Joined: 25 Jun 2008
Posts: 17447
|
you could increase the wait timeout
or switch to dmpmqcfg. |
|
| Back to top |
|
|
| Tdak |
| Posted: Wed Dec 04, 2013 3:30 am Post subject: |
|
|
Novice
Joined: 30 Jun 2008
Posts: 18
Location: South Africa
|
| Hi Mqjeff, bruce2359 and gbaddeley - thank you for your assistance - the put attribute was disabled on the command queue - this was enabled and we were able to back up the objects afterwards. |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
