MQSeries.net :: View topic - JMS node configuration problem

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » JMS node configuration problem

JMS node configuration problem

« View previous topic :: View next topic »

Author

Message

premji

Posted: Thu Nov 21, 2013 5:15 am Post subject: JMS node configuration problem

Acolyte

Joined: 01 Jul 2013
Posts: 64

Hi All,

I am working on IIBv9. I have taken JMS sample from IIB and I have given queue names which I have configured in MQ, that is working fine.The problem is when I constructing flow with JMSInput node manually that flow is not triggered even I following same procedure of sample flow, Can any one give me some solution where I did mistake like I need to run any commands for JMS node

Esa

Posted: Thu Nov 21, 2013 5:28 am Post subject:

Grand Master

Joined: 22 May 2008
Posts: 1387
Location: Finland

In JMSInput nodes JMS Connection tab, what did you put in
- Location JNDI bindings
- Connection factory name?

premji

Posted: Thu Nov 21, 2013 10:01 am Post subject: Hi Thanks for your reply I resolved that problem.

Acolyte

Joined: 01 Jul 2013
Posts: 64

I removed Application Property under message selectors of JMSInput node then it's working fine

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » JMS node configuration problem

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP