MQSeries.net :: View topic - Websphere Adapater Deployment error in broker v7

AKSHAYA · Posted: Fri Jun 15, 2012 2:27 am Post subject:

Hello,

While deploying the Web sphere SAP Adaptor message flow .we are getting the below error.

System Information:

OS â€“AIX61/Windows( Broker is running in AIX & toolkit is in Windows
Broker version-v7004.
SAPJco -Version-3

Error Details:

Begin running task [Deploying [Test.bar] to execution group [WBISAPAdapter]]BIP2087E: Broker PBD1MWS1BK was unable to process the internal configuration message.
The entire internal configuration message failed to be processed successfully. Use the messages following this message to determine the reasons for the failure. If the problem cannot be resolved after reviewing these messages, contact your IBM Support center. Enabling service trace may help determine the cause of the failure.BIP4041E: Execution group 'WBISAPAdapter' received an invalid configuration message. See the following messages for details of the error. The broker was asked to deploy a message flow which contained properties that were not recognized by the broker. This typically results from a message flow requiring a version or type of node that is not supported by the broker installation. Check that the message flow is only using properties or nodes that are supported on the broker. Check that all necessary user-defined extensions are installed and that they are of a version that is compatible with the message flow.BIP3414E: An attempt to attach the message flow node 'SAP2MB.INPUT' in message flow 'PB_SAP2MB_R3_IDOC' to the adapter component 'PB_SAP2MB_R3_IDOC.inadapter' failed. Reason: com.sap.conn.jco.JCoException: (108) JCO_ERROR_INTERNAL: Unable to find the server instance, despite... (data of len 126 truncated). The message flow node failed to register with the adapter component to receive events. The node cannot function correctly until it has attached to the adapter component. Identify the adapter that is required by the node. Ensure that it is deployed to the correct execution group, and that the connection details on the .inadapter and the configurable service are correct. In addition, check the system log or Windows Event Viewer for further errors. If the problem persists, redeploy the message flow that contains the node and the adapter component that the node requires. The reason given in the error message might provide additional information about what caused the problem.
BIP3450E: An adapter error occurred during the processing of a message. The adapter error message is 'com.sap.conn.jco.JCoException: (108) JCO_ERROR_INTERNAL: Unable to find the server instance, despite... (data of len 197 truncated)'. This error was detected by the adapter. The following message describes the diagnostic information that is provided by the adapter 'com.sap.conn.jco.JCoException: (108) JCO_ERROR_INTERNAL: Unable to find the server instance, despite... (data of len 197 truncated)'. Inspect the diagnostic information that is provided by the adapter. Further diagnostic information might be written to user trace. Inspect user trace for further information.The task was unsuccessful: The deployment was unsuccessful. Check error messages above for explanation.

Any inputs will be appriciated !!

Thanks,
Aks