MQSeries.net :: View topic

swann · Posted: Sat Dec 03, 2011 8:13 am Post subject: mqsiprofile

Hi,
I have installed the MB 7 on aix on usr/mqbroker filesystem.I tried to source the mqsiprofile by . ./mqsiprofile on /usr/mqbroker/bin the it was showing the MB version installed.But when i tried to run mqsi commands it shows the following error:

Failed to open file /var/mqsi/registry/utility/HASharedWorkPath with error The file access permissions do not allow the specified action.
BIP2113E: Message broker internal error: diagnostic information ''The file access permissions do not allow the specified action.'', '13', ''/var/mqsi/registry/utility/HASharedWorkPath''.
An internal software error has occurred in the message broker. Further messages will indicate the effect of this error on the broker's transactions.
Shutdown and restart the message broker. If the problem continues to occur, then restart the system. If the problem still continues to occur contact your IBM support center.

BIP8081E: An error occurred while processing the command.
An error occurred while the command was running; the command has cleaned up and ended.
Use messages prior to this one to determine the cause of the error.
Check for some common problems:
Does the user id have the correct authorities (for example a member of the mqbrkrs group)?
Is any operating system limit set too low to allow the command to run?
Is the environment correctly set up?
Correct the problem and retry the command, otherwise, contact your IBM support center.

So could anyone help how to solve this problem, i mean how to run the mqsi commands?