MQSeries.net :: View topic - Configure multiple Channels for Triggering

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » General IBM MQ Support » Configure multiple Channels for Triggering

Configure multiple Channels for Triggering

« View previous topic :: View next topic »

Author

Message

sijtom0703

Posted: Wed Nov 09, 2011 4:42 am Post subject: Configure multiple Channels for Triggering

Voyager

Joined: 28 May 2011
Posts: 84
Location: USA

I have three Sender Channels to be triggered when a message first arrives on my application queue.

E.g.

I have Sender Channels
(QM1.TO.QM2, QM1.TO.QM3 and QM1.TO.QM4)

The XmitQ QT1 in QM1 is set for Trigger Type FIRST

Can I configure all the three Channel Names in TRIGDATA of XmitQ QT1 so that all the three Sender Channel starts when the first message arrives in the XmitQ.

mqjeff

Posted: Wed Nov 09, 2011 5:05 am Post subject:

Grand Master

Joined: 25 Jun 2008
Posts: 17447

You can't share XMITQs between channels, except the Cluster Xmitq.

So, no, you can't do whatever you think you are trying to do.

Tell us what you think you are trying to do, and we'll suggest some correct ways to get there.

sijtom0703

Posted: Wed Nov 30, 2011 12:26 pm Post subject:

Voyager

Joined: 28 May 2011
Posts: 84
Location: USA

Thanks!

Sorry that was a dump question..I realized after posting it

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » General IBM MQ Support » Configure multiple Channels for Triggering

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP