MQSeries.net :: View topic - MQ on win2k adding a second NIC card

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » IBM MQ Installation/Configuration Support » MQ on win2k adding a second NIC card - get csqx202e rc=468

MQ on win2k adding a second NIC card - get csqx202e rc=468

« View previous topic :: View next topic »

Author

Message

kme_1998

Posted: Thu Feb 20, 2003 7:44 am Post subject: MQ on win2k adding a second NIC card - get csqx202e rc=468

Novice

Joined: 04 Jun 2001
Posts: 14

Trying to pick out why it fails to connect, or more specifically how to make MQ Series Server happy in a multiple NIC environment. Didn't seee any similar examples. Suggestions welcome.

win2k send channel to MVS qmgr is ok. But sender channel from mq on MVS to win2k is in retry as soon as we added 2nd NIC.
get csqx202e rc=468

I'm think it gets confuse about what interface to go out on, but only guessing.

bbeardsley

Posted: Thu Feb 20, 2003 9:25 am Post subject:

Acolyte

Joined: 17 Dec 2001
Posts: 52
Location: Dallas, TX, USA

Hmm. We just added a NIC on W2K, and here's the checklist I used:

1. Try to ping your W2K box from MVS.
1. Verify the IP address is correct on your MVS sender channel.
2. Verify TCP/IP is configured for your NIC. (I assume you're using TCP due to the rc=468.)
3. Verify your listener is started and listening on the correct port. (netstat)

Good Luck
-Bridgette Beardsley

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » IBM MQ Installation/Configuration Support » MQ on win2k adding a second NIC card - get csqx202e rc=468

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP