MQSeries.net :: View topic - how to set headers for pub/sub

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » how to set headers for pub/sub

how to set headers for pub/sub

« View previous topic :: View next topic »

Author

Message

kumar_eee07

Posted: Mon Jun 14, 2010 9:11 pm Post subject: how to set headers for pub/sub

Newbie

Joined: 14 Jun 2010
Posts: 5

how to set headers for pub/sub. please advise me from scratch onwards/

i mean how to publish and subscribe to the particular topic plz give eloborative information

smdavies99

Posted: Mon Jun 14, 2010 9:17 pm Post subject:

Jedi Council

Joined: 10 Feb 2003
Posts: 6076
Location: Somewhere over the Rainbow this side of Never-never land.

The WMQ Documentation is a good place to start. Pub/Sub is not only available to Broker USers.

Then take a look at the IH03 Support Pack, especially the RFHUtil application.
Then take a look at the documentation (In Broker) on how to subscribe to say FlowMonitoring Events.

Then Finally, look at the Samples section of your toolkit.

This should give you a good background and let you start 'playing' around with it.
Then by all means come back with more specific questions. It is not that difficult.
_________________
WMQ User since 1999
MQSI/WBI/WMB/'Thingy' User since 2002
Linux user since 1995

Every time you reinvent the wheel the more square it gets (anon). If in doubt think and investigate before you ask silly questions.

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » how to set headers for pub/sub

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP