| Author |
Message
|
| raz |
 Posted: Fri Aug 01, 2008 6:18 am Post subject: LOCLADDR attribute on channel defination |
 |
|
Acolyte
Joined: 10 Jul 2007
Posts: 70
|
| I read in intercommunication manual about LOCLADDR attribute but didn't understand. Please could anybody explain me about this. |
|
| Back to top |
|
 |
| fjb_saper |
| Posted: Fri Aug 01, 2008 8:00 am Post subject: Re: LOCLADDR attribute on channel defination |
|
|
Grand High Poobah
Joined: 18 Nov 2003
Posts: 20756
Location: LI,NY
|
| raz wrote: |
| I read in intercommunication manual about LOCLADDR attribute but didn't understand. Please could anybody explain me about this. |
Which part did you not understand. Do you even have a computer with multiple network cards / multiple ip addresses?
Enjoy 
_________________
MQ & Broker admin |
|
| Back to top |
|
|
| raz |
| Posted: Fri Aug 01, 2008 12:05 pm Post subject: |
|
|
Acolyte
Joined: 10 Jul 2007
Posts: 70
|
yes, My server has got two IP addresses, one is physical and another one is virtual IP.while sending out messages I want use one particuler IP.
Thanks |
|
| Back to top |
|
|
| raz |
| Posted: Mon Aug 04, 2008 9:47 am Post subject: |
|
|
Acolyte
Joined: 10 Jul 2007
Posts: 70
|
|
| Back to top |
|
|
| markt |
| Posted: Mon Aug 04, 2008 9:51 am Post subject: |
|
|
Knight
Joined: 14 May 2002
Posts: 508
|
| which part of the documentation did you not understand? It seems pretty clear to me. |
|
| Back to top |
|
|
| raz |
| Posted: Mon Aug 04, 2008 10:31 am Post subject: |
|
|
Acolyte
Joined: 10 Jul 2007
Posts: 70
|
Why we use LOCALADDR attribute? could CONNAME and LOCALADDR be same?
Thanks |
|
| Back to top |
|
|
| bruce2359 |
| Posted: Mon Aug 04, 2008 11:33 am Post subject: |
|
|
Poobah
Joined: 05 Jan 2008
Posts: 9469
Location: US: west coast, almost. Otherwise, enroute.
|
From the WMQ Intercommunication manual:
Local Address (LOCLADDR)
This attribute specifies the local communications address for the channel. When a LOCLADDR value is specified, a channel that is stopped and then restarted continues to use the TCP/IP address specified in LOCLADDR. In recovery scenarios, this could be useful when the channel is communicating through a firewall, because it removes problems caused by the channel restarting with a different IP address, specified by the TCP/IP stack to which it is connected. You can also use this attribute to force a channel to use an IPV4 or an IPV6 stack on a dual stack system or use a dual mode stack on a single stack system.
The value used is the optional IP address and optional port or port range to be used for outbound TCP/IP communications. The format is as follows: LOCLADDR([ip-addr][(low-port[,high-port])])
_________________
I like deadlines. I like to wave as they pass by.
ב''ה
Lex Orandi, Lex Credendi, Lex Vivendi. As we Worship, So we Believe, So we Live. |
|
| Back to top |
|
|
|
|
