ASG
IBM
Zystems
Cressida
Icon
Netflexity
 
  MQSeries.net
Search  Search       Tech Exchange      Education      Certifications      Library      Info Center      SupportPacs      LinkedIn  Search  Search                                                                   FAQ  FAQ   Usergroups  Usergroups
 
Register  ::  Log in Log in to check your private messages
 
RSS Feed - WebSphere MQ Support RSS Feed - Message Broker Support

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » BIP8078E: cannot create a configuration manager

Post new topic  Reply to topic
 BIP8078E: cannot create a configuration manager « View previous topic :: View next topic » 
Author Message
kevinobyrne
PostPosted: Thu Feb 21, 2008 10:39 am    Post subject: BIP8078E: cannot create a configuration manager Reply with quote

Voyager

Joined: 17 Jul 2007
Posts: 83
Location: Ireland

Hi there,
I was having a problem with my default setup, could not deploy to my broker, it would timeout every time, even if I set the timeout, so I reinstalled Websphere Message Broker, on the recommendations of a colleague.

The problem I'm having now is I can create a configuration manager.

I've created a new QM, "LOCAL"
and a DB for the Broker
mqsicreatedb LOCALDB
then I created the broker successfully
mqsicreatebroker LOCAL_BRKR -i <username> -a <pswd> -q LOCAL -n LOCALDB
but then I try and create the Config mgr
mqsicreateconfigmgr LOCAL_CM -i <username> -a <pswd> a -q LOCAL -n LOCALDB
This is the output I'm getting:

    BIP1223I: Attempting to open and migrate DB2 database 'LOCALDB'...
    BIP1228I: The Configuration Manager repository has been successfully created.
    Error in event log... ReportEvent() failed
    BIP8078E: A problem was encountered while attempting to create/delete the Config
    uration Manager.
    The operation was not completed successfully.


The configuration manager is not created, but I'm not seeing any messages in the event log either. I've searched this site for similar problems but can't find anything, i'm sure I have the username/pswd combination correct, otherwise I wouldn't be able to create the broker.

Any suggestions appreciated, thanks.
Back to top
View user's profile Send private message
jefflowrey
PostPosted: Thu Feb 21, 2008 11:19 am    Post subject: Reply with quote

Grand Poobah

Joined: 16 Oct 2002
Posts: 19981

ConfigMgr doesn't need any database parameters on mqsicreateconfigmgr, if you're creating a new ConfigMgr.

These are only used for migrating an existing ConfigMgr.
_________________
I am *not* the model of the modern major general.
Back to top
View user's profile Send private message
kevinobyrne
PostPosted: Fri Feb 22, 2008 1:23 am    Post subject: Reply with quote

Voyager

Joined: 17 Jul 2007
Posts: 83
Location: Ireland

Thank you
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic  Reply to topic Page 1 of 1

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » BIP8078E: cannot create a configuration manager
Jump to:  



You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
Protected by Anti-Spam ACP
 
 


Theme by Dustin Baccetti
Powered by phpBB © 2001, 2002 phpBB Group

Copyright © MQSeries.net. All rights reserved.