MQSeries.net :: View topic - SOAPRequest

telecoda

Hi I am using WMB 6.1 and trying to get to grips with the new SOAP nodes.

I am invoking a web service that generates a SOAP fault. I would expect this to be routed down the "Fault" terminal. However it is being routed down the failure terminal with the following exception.

"A SOAP Request node received a SOAP Fault response message, but the HTTP Status code was Success (2xx)."

After a little HTTP monitoring it appears that the SOAP fault is being returned in valid syntax but an HTTP 200 code is on the response header instead of the recommended HTTP 500 code.

Is there any way to relax Message Brokers adherance to this standard rather that asking the application vendor to toe the line?

The webservice appears to be "axis" based.

Thanks for any help.