MQSeries.net :: View topic

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » IBM MQ Installation/Configuration Support » STRMQCFG flag

STRMQCFG flag

« View previous topic :: View next topic »

Author

Message

sebastia

Posted: Thu May 24, 2007 1:11 am Post subject: STRMQCFG flag

Grand Master

Joined: 07 Oct 2004
Posts: 1003

running "strmqcfg /?" displays

Correct syntax is
strmqcfg [-d]

1) what is the use of the "-d" flag ?

2) where is it documented ??

Thanks. S.

sebastia

Posted: Thu May 24, 2007 1:52 am Post subject:

Grand Master

Joined: 07 Oct 2004
Posts: 1003

MQ v 6 Sys Admin Guide says

strmqcfg (start WebSphere MQ Explorer)

The syntax of this command follows: strmqcfg -c -i

Optional parameters
-c -clean is passed to Eclipse. This causes Eclipse to delete any cached data used by the Eclipse runtime.

-i -init is passed to Eclipse. This causes Eclipse to discard configuration information used by the Eclipse runtime.

========================================

where is "-d" ???

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » IBM MQ Installation/Configuration Support » STRMQCFG flag

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP