Posted: Sun Feb 11, 2007 1:15 am Post subject: WMQ fails under MSCS cluster with no error messages
Newbie
Joined: 11 Feb 2007 Posts: 9
Hi,
I'm using WMQ v 6 with refresh pack 2 under MSCS.
I saw a few times (about once a day) that the cluster detected that MQ has failed (event ID 1069) and then caused the cluster to failover
When I tried to investigate the problem, I didn't find any MQ errors before the failure was detected.
could it be that the cluster manager detected a failure although MQ was running fine? is it possible to enable tracing for the resource monitor?
Any indications outside of WMQ, e.g. cluster resouce problems such as the IP Address dropping out? _________________ It's puzzling, I don't think I've ever seen anything quite like this before...and it's hard to soar like an eagle when you're surrounded by turkeys.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum