| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| User Account getting locked out for the MQSI |
« View previous topic :: View next topic » |
| Author |
Message
|
| paulgroo |
 Posted: Tue Nov 07, 2006 2:46 am Post subject: User Account getting locked out for the MQSI |
 |
|
Centurion
Joined: 07 Jul 2005
Posts: 138
Location: Ireland
|
Hi everyone,
We have the MQSI and DB2 services all starting up on a Windows service using the db2admin account. This normally works fine and everything starts without any difficulty, but over the past few days we've been noticing that the db2admin account is getting locked out a lot (and subsequently services arent starting which is leading to users having emotional problems...).
So here's the question: the db2admin account is used when starting the services, and I'v set the password correctly in here. There are also entries in ODBC of course which use the db2admin account and password (Im sure this is also set correctly). Is there somewhere else on the system that this password might be set (incorrectly) and is forcing the account to lock out? |
|
| Back to top |
|
 |
| fjb_saper |
| Posted: Tue Nov 07, 2006 3:59 am Post subject: |
|
|
Grand High Poobah
Joined: 18 Nov 2003
Posts: 20756
Location: LI,NY
|
have you tried mqsisetdbparms to update the password for the broker? 
_________________
MQ & Broker admin |
|
| Back to top |
|
|
| jefflowrey |
| Posted: Tue Nov 07, 2006 4:31 am Post subject: |
|
|
Grand Poobah
Joined: 16 Oct 2002
Posts: 19981
|
If paulgroo is using MQSI, then there is no mqsisetdbparms.
Hopefully, paulgroo is using at least WBIMB.
Hopefully, also, paulgroo used mqsichangebroker to change the db2admin password for Broker and not just changed it in Services control panel.
_________________
I am *not* the model of the modern major general. |
|
| Back to top |
|
|
| paulgroo |
| Posted: Fri Nov 24, 2006 6:52 am Post subject: |
|
|
Centurion
Joined: 07 Jul 2005
Posts: 138
Location: Ireland
|
Hi.
No, paulgroo was only using MQSI 2.1 although we're currently upgrading to WebSphere Message Broker 6.0
Yes, paulgroo did use the mqsichangebroker command and everything worked fine.
Thanks everyone! |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
