MQSeries.net :: View topic - MQ Snap-in problems

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » IBM MQ Installation/Configuration Support » MQ Snap-in problems

MQ Snap-in problems

« View previous topic :: View next topic »

Author

Message

Giridhar

Posted: Wed Jun 07, 2006 6:53 am Post subject: MQ Snap-in problems

Apprentice

Joined: 23 Nov 2005
Posts: 46

I am trying to connect to an application using a snap-in. Everytime I put a message on the snap-in queue, the message is put on the error queue and the format is MQDEAD.

MQ is also recording a warning on the application log with this message "mipcd.state.mi.us[1] Unable to deliver message: no translation from the input character set to Unicode was available . The message has been moved to the error queue. 1 message(s) have been placed in the error queue by this router. "

Could anybody tell me if this is a MQ configuration problem......or any solutions to this.

Giridhar

Posted: Wed Jun 07, 2006 7:56 am Post subject:

Apprentice

Joined: 23 Nov 2005
Posts: 46

I am getting another message on the log too. May be this makes sense.

"mipcd.state.mi.us[1] Unable to deliver message: the input message type is unsupported . The message has been moved to the error queue. 2 message(s) have been placed in the error queue by this router."

wschutz

Posted: Wed Jun 07, 2006 4:11 pm Post subject:

Jedi Knight

Joined: 02 Jun 2005
Posts: 3316
Location: IBM (retired)

What "snap-in" are you using?

How are you putting these messages to the "snap-in" queue?
_________________
-wayne

Giridhar

Posted: Thu Jun 08, 2006 4:56 am Post subject:

Apprentice

Joined: 23 Nov 2005
Posts: 46

Hi Wayne,

I am using the Unisys MQ snap-in to connect to the Unisys mainframe apps. The snap-in (plug-in) allows me to configure it with a Queue Manager and Queues already created and running in MQ. I put messages in the Queue Manager. Hopefully this will shed some light.

Giri

Giridhar

Posted: Thu Jun 08, 2006 5:04 am Post subject:

Apprentice

Joined: 23 Nov 2005
Posts: 46

It is a translation problem. The snap-in is not converting from Ascii to EBCIDIC and vice-versa.

It also says in the documentation that "Character set conversion can only be achieved if th code page that corresponds to the CCSID property of the message is installed on the sys".

Is this an MQ problem? If so, could you shed some light on how or where to find the character code page so that I could install it?

Thank You
Giri

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » IBM MQ Installation/Configuration Support » MQ Snap-in problems

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP