| Author |
Message
|
| drano |
 Posted: Fri May 03, 2002 10:45 am Post subject: |
 |
|
Novice
Joined: 02 May 2002
Posts: 15
Location: Serv'N Data
|
When I try to debug a flow, I have an BIP0642E error (I/O problem)
On an other machine, I have no problem with the same flow...
How solve this problem? Reinstall ? Change network parameters ?
My Os is winNT... |
|
| Back to top |
|
 |
| kirani |
| Posted: Fri May 03, 2002 5:03 pm Post subject: |
|
|
Jedi Knight
Joined: 05 Sep 2001
Posts: 3779
Location: Torrance, CA, USA
|
I don't think you will have to reinstall WMQI for this. Looks like it is a network problem. Do you have broker on the same machine? What version of MQSI/WMQI are you using and what CSD level? Is there any error logged into your Event Viewer? Have you tried debugging message flow again or Can you simulate this error?
_________________
Kiran
IBM Cert. Solution Designer & System Administrator - WBIMB V5
IBM Cert. Solutions Expert - WMQI
IBM Cert. Specialist - WMQI, MQSeries
IBM Cert. Developer - MQSeries
|
|
| Back to top |
|
|
| drano |
| Posted: Sat May 04, 2002 7:52 am Post subject: |
|
|
Novice
Joined: 02 May 2002
Posts: 15
Location: Serv'N Data
|
Broker is on an other machine.
MQSI 2.1
CSD 2
I didn't see an error in Event Viewer
I tried several times to debug my flow, an other flows, but
it is the same problem
In my debugger, I saw the first step (after receive a message in queue),
and after, error... |
|
| Back to top |
|
|
| kwelch |
| Posted: Fri May 17, 2002 12:08 pm Post subject: Debugger and BIP0642 |
|
|
Master
Joined: 16 May 2001
Posts: 255
|
Did you ever find out what the problem was? I am experiencing the same thing. I get no messages in the event viewer. It ignores prior breakpoints as well and doesn't seem to error in the same place every time, even though I make no changes. I am running WMQI 2.1 CSD 2 on the box where the broker lives. I am connecting from my pc which is at CSD1.
Any suggestions are appreciated. Thanks.
Karen |
|
| Back to top |
|
|
| michaelpatton |
| Posted: Tue May 21, 2002 7:21 pm Post subject: |
|
|
Apprentice
Joined: 21 May 2002
Posts: 25
Location: East Coast USA
|
| The BIP0642 message can be issued when you try to use the debugger on a flow that has unconnected nodes. |
|
| Back to top |
|
|
| kwelch |
| Posted: Wed May 22, 2002 2:57 am Post subject: |
|
|
Master
Joined: 16 May 2001
Posts: 255
|
Thanks Michael but that is not the case with this messageflow. It is not consistent either at which node it happens on. It also seems to ignore prior breakpoints and usually happens, but not always, after whereever the first breakpoint is.
Karen |
|
| Back to top |
|
|
|
|
