ASG
IBM
Zystems
Cressida
Icon
Netflexity
 
  MQSeries.net
Search  Search       Tech Exchange      Education      Certifications      Library      Info Center      SupportPacs      LinkedIn  Search  Search                                                                   FAQ  FAQ   Usergroups  Usergroups
 
Register  ::  Log in Log in to check your private messages
 
RSS Feed - WebSphere MQ Support RSS Feed - Message Broker Support

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » Publishing a message with RFH2 usr section issue

Post new topic  Reply to topic
 Publishing a message with RFH2 usr section issue « View previous topic :: View next topic » 
Author Message
somsayan
PostPosted: Mon Aug 13, 2012 8:37 pm    Post subject: Publishing a message with RFH2 usr section issue Reply with quote

Apprentice

Joined: 06 Apr 2007
Posts: 49
I'm using Broker 8.0.0.0
The MQ version is 7.0.1.0

Our requirement is to keep the track of the start time of a service. This service will have the message published and subscribed multiple times. So we thought of keeping the start time of the first flow in the MQRFH2 usr section.
But unfortunately on publishing the message, we are loosing the RFH2 usr information. But, when we are trying to publish the message without the usr section, the message seems to be doing fine. Also putting the message with usr section directly to a queue is working fine.
The problem is only when we are trying to merge the two functionalities. Are we missing something ??

Regards
Som
Back to top
View user's profile Send private message
mqjeff
PostPosted: Tue Aug 14, 2012 1:58 am    Post subject: Reply with quote

Grand Master

Joined: 25 Jun 2008
Posts: 17447
You probably need to be at a higher fixpack than 7.0.1.0 to get support for MB v8.0.0.0.

MQ v7 and later doesn't use the RFH2, it uses Message Properties instead. Despite that, Broker has not been updated to support Properties, even after two separate versions that state that they support mq V7.

You don't say how you are determining that you are 'loosing the RFH2 usr information'. It may simply be that it's been mapped into properties and you don't see it when you look for an RFH2.

Otherwise look at PROPCTL.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic  Reply to topic Page 1 of 1

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » Publishing a message with RFH2 usr section issue
Jump to:  



You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
Protected by Anti-Spam ACP
  
 


Theme by Dustin Baccetti
Powered by phpBB © 2001, 2002 phpBB Group

Copyright © MQSeries.net. All rights reserved.