| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| Trigger Monitor using MQ Services |
« View previous topic :: View next topic » |
| Author |
Message
|
| jillsam |
 Posted: Thu Mar 06, 2003 9:38 pm Post subject: Trigger Monitor using MQ Services |
 |
|
Newbie
Joined: 27 Jun 2002
Posts: 7
|
To start a trigger monitor, go into MQServices. Right click on the queue manager name and select new->Trigger Monitor. Fill in the details.
What should be filled in for queue name? What if it was left blank?
Thanks
_________________
http://www.materialsforum.net
Last edited by jillsam on Thu Jun 17, 2004 5:30 am; edited 1 time in total |
|
| Back to top |
|
 |
| RogerLacroix |
| Posted: Thu Mar 06, 2003 9:53 pm Post subject: |
|
|
Jedi Knight
Joined: 15 May 2001
Posts: 3264
Location: London, ON Canada
|
Check your application triggered queue for the INITQ attribute.
Then put the INITQ attribute value as your trigger monitor's initiation queue.
The default initiation queue for the trigger monitor is SYSTEM.DEFAULT.INITIATION.QUEUE
later
Roger...
_________________
Capitalware: Transforming tomorrow into today.
Connected to MQ!
Twitter |
|
| Back to top |
|
|
| AlexeiSkate |
| Posted: Fri Jun 20, 2003 12:16 pm Post subject: |
|
|
Centurion
Joined: 10 Apr 2002
Posts: 123
|
jillsam or Roger,
Were either of you able to trigger your application ok when you defined the trigger monitor under the MQServices? For the longest time now I cannot get my application to be triggered when I define the trigger monitor via MQServices; however, when I start the trigger monitor via the DOS command ">runmqtrm -m ... -q...", I'm able to trigger my application program fine. Any suggestions?
Thanks,
Alex |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
