| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| Destination List |
« View previous topic :: View next topic » |
| Author |
Message
|
| Hari |
 Posted: Tue Mar 11, 2003 11:32 pm Post subject: Destination List |
 |
|
Centurion
Joined: 21 Nov 2002
Posts: 117
Location: USA
|
Hi,
I have a message flow which uses Destination List for assigning the output queue dynamically. Also what i have is i send a reply message to the ReplyQ.
Now my problem is that when i pass on a message i get the Reply message in the reply queue but i dont get the required message in the required output queue.
While running it in the debug mode i am able to see the queue name in the destination data list. But finally i dont get the message in the output queue.
Please note that the Destination Mode has also been set to the Destination List.
Please advice.
Regards,
Hari |
|
| Back to top |
|
 |
| lillo |
| Posted: Wed Mar 12, 2003 12:07 am Post subject: |
|
|
Master
Joined: 11 Sep 2001
Posts: 224
|
In the MQOutput node which send the message to the destinatio queue, did you set the Destination Mode property in the Advance tab to Destination ?
Cheers,
_________________
Lillo
IBM Certified Specialist - WebSphere MQ |
|
| Back to top |
|
|
| patelp |
| Posted: Wed Mar 19, 2003 6:14 am Post subject: |
|
|
Newbie
Joined: 19 Mar 2003
Posts: 2
|
Hi,
In the Compute node where you are populating the OutputDestinationlist with the Out queue name, under Advanced tab, put Compute Mode as 'All' and then try.....
_________________
Thanks,.. |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
