MQSeries.net :: View topic - Windows to AIX MQ queue manager access problem

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » General Discussion » Windows to AIX MQ queue manager access problem

Goto page Previous 1, 2

Windows to AIX MQ queue manager access problem

« View previous topic :: View next topic »

Author

Message

sami.stormrage

Posted: Wed Jul 30, 2008 7:05 am Post subject:

Disciple

Joined: 25 Jun 2008
Posts: 186
Location: Bangalore/Singapore

Yeah.. saw that.. reason could be no messages were there to transfer.. You haven't seen the last of sami yet..

.. will be back after dinner ..

_________________
*forgetting everything

exerk

Posted: Wed Jul 30, 2008 7:11 am Post subject:

Jedi Council

Joined: 02 Nov 2006
Posts: 6339

sami.stormrage wrote:

Yeah.. saw that.. reason could be no messages were there to transfer.. You haven't seen the last of sami yet..

.. will be back after dinner ..

SVRCONN channels can be in a running condition with NO messages being transferred across them

SVRCONN channels do not start until a successful incoming connection is made!

I suggest you do a bit of testing to satisfy yourself, i.e. check state of a SVRCONN with nothing connected, then connect to it and recheck state, then disconnect and recheck state.
_________________
It's puzzling, I don't think I've ever seen anything quite like this before...and it's hard to soar like an eagle when you're surrounded by turkeys.

sami.stormrage

Posted: Wed Jul 30, 2008 7:39 am Post subject:

Disciple

Joined: 25 Jun 2008
Posts: 186
Location: Bangalore/Singapore

http://www.mqseries.net/phpBB2/viewtopic.php?t=16579

Post is misleading.. may be I will setup a client and test all the scenarios out and get back to the post..
_________________
*forgetting everything

gogo

Posted: Wed Jul 30, 2008 6:45 pm Post subject:

Novice

Joined: 28 Jul 2008
Posts: 11

sami.stormrage wrote:

Just restart the channel and see if it works

CHANEL1!
The case was with MQ installation done by admin in vacation. The config was not finished I see.
I have tried dft first but it didn't work. Alter chanel1 with 'mqm'...
estart of mq by your advice for a case. It works now.
Thanks!

Display posts from previous:

Goto page Previous 1, 2

Page 2 of 2

MQSeries.net Forum Index » General Discussion » Windows to AIX MQ queue manager access problem

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP