MQSeries.net :: View topic - Message set Migration Issue

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » Message set Migration Issue

Message set Migration Issue

« View previous topic :: View next topic »

Author

Message

MSAT

Posted: Wed Nov 16, 2005 7:38 pm Post subject: Message set Migration Issue

Acolyte

Joined: 17 Aug 2005
Posts: 62
Location: Bengalooru

Hi,
I migrated WMQI V2.1+FP5 to WBIMB V5.0+FP5 the entire migration went fine. But for some of the message sets the Max Occurs field in one of the Compound element changed from 254 to -1. I specified -g option during mqsimigratemsgsets command.
I checked in the WBIMB help about Max Occurs =-1 according to that it should work fine. But it is not able to parse the message if the compound element repeats more than once. If I change the value from -1 to 254 it works fine.

I wanted to know why the value changed from 254 to -1

Hope I will get a reply

Thanks
MSAT

kimbert

Posted: Thu Nov 17, 2005 5:18 am Post subject:

Jedi Council

Joined: 29 Jul 2003
Posts: 5542
Location: Southampton

Sounds a bit strange to me. All the same, I don't see why it should change the behaviour (unless your input message contains at least 255 repeats!).

MSAT

Posted: Thu Nov 17, 2005 5:55 pm Post subject:

Acolyte

Joined: 17 Aug 2005
Posts: 62
Location: Bengalooru

Thanks for the reply.
After migration the problem I faced was if the repeating element in the message appears only once then the parser was able to parse it correctly. But if it appears more than once the parser treating it as a single value and not able to parse the content. The message set is MRM Delimited Form.

Once I changed the Max Occurs value of the compound element(which can repeat more than once also) from -1 to 254 it worked fine. Why is it so?

Thanks
Sat

ayanc

Posted: Thu Nov 17, 2005 8:41 pm Post subject:

Voyager

Joined: 15 Nov 2004
Posts: 88

Hi,

I would like to add a similar situation faced during migration of message sets.

The Repeating Element Delimiter property for a TDS message was not reflected during migration from v2.1 to v5.0

Is it possible to know why? Maybe ppl from IBM can help.

Thanks.

shanson

Posted: Fri Nov 18, 2005 1:50 am Post subject:

Partisan

Joined: 17 Oct 2003
Posts: 344
Location: IBM Hursley

You'll have to raise PMRs for IBM to investigate these two mqsimigratemsgsets problems. Neither of them have been reported before.

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » Message set Migration Issue

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP