| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| MQSI on Win2k |
« View previous topic :: View next topic » |
| Author |
Message
|
| lohit |
 Posted: Wed Jun 25, 2003 4:22 am Post subject: MQSI on Win2k |
 |
|
Novice
Joined: 29 May 2003
Posts: 20
|
HI
I have installed mqseries 5.3 and Mqsi 2.0.2 on my win 2k workstation.
I successfully created the config manager and the broker, both were started properly.
My problem is that I have to install some message flows.
In the MQSI control centre, assignments tab, under the brokers heading I dont find my broker listed.
My broker and Config manager are sharing the same Queue manager.
are there any steps to be taken so that the broker is visible in the control centre
Please advice.
Thanks for your help
Regards
Lohit |
|
| Back to top |
|
 |
| shalabh1976 |
| Posted: Wed Jun 25, 2003 4:42 am Post subject: |
|
|
Partisan
Joined: 18 Jul 2002
Posts: 381
Location: Gurgaon, India
|
This might be security issue.
Check that you have sufficient authority to perform this action |
|
| Back to top |
|
|
| jefflowrey |
| Posted: Wed Jun 25, 2003 5:22 am Post subject: |
|
|
Grand Poobah
Joined: 16 Oct 2002
Posts: 19981
|
Actually, I think if you don't have authority to do assignments, you won't see the Assignments tab at all.
It sounds like he didn't add his broker to his ConfigMgr topology. This doesn't happen automatically. You need to go to the Topology tab, check out the Topology, add your broker, and then check in and deploy the Topology. |
|
| Back to top |
|
|
| lohit |
| Posted: Wed Jun 25, 2003 7:59 pm Post subject: |
|
|
Novice
Joined: 29 May 2003
Posts: 20
|
Thank you!!
that did the trick.
Regards
Lohit |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
