ASG
IBM
Zystems
Cressida
Icon
Netflexity
 
  MQSeries.net
Search  Search       Tech Exchange      Education      Certifications      Library      Info Center      SupportPacs      LinkedIn  Search  Search                                                                   FAQ  FAQ   Usergroups  Usergroups
 
Register  ::  Log in Log in to check your private messages
 
RSS Feed - WebSphere MQ Support RSS Feed - Message Broker Support

MQSeries.net Forum Index » IBM MQ Installation/Configuration Support » Installing Exits Channel on NSK.

Post new topic  Reply to topic
 Installing Exits Channel on NSK. « View previous topic :: View next topic » 
Author Message
LuisFer
PostPosted: Sat Feb 01, 2003 12:59 am    Post subject: Installing Exits Channel on NSK. Reply with quote

Partisan

Joined: 17 Aug 2002
Posts: 302
I have a problem with Conexion Tandem <==> OS/390.
We have a RCVR/CLUSRCVR message channel exit in the OS/390 (Assembler) to validate the PartnerName from the messages. From OS/390 <==> OS/390 the exit works fine, but in the NSK, when i started the channel always send me the AMQ9XXX User Exit not valid (in CLUSRCVR automatic Channel).
Somebody had installed a Exit in NSK?
Thanks
Back to top
View user's profile Send private message
mqonnet
PostPosted: Mon Feb 03, 2003 6:02 am    Post subject: Reply with quote

Grand Master

Joined: 18 Feb 2002
Posts: 1114
Location: Boston, Ma, Usa.
Did you compile the load exit and have the load entry properly defined in your channel exit program.

Make sure that your SCYEXIT specifies your channel exit name properly. Guess it is case sensitive.

For testing purposes i would also add a printf somewhere at the beginning of the channel exit to see if we are gettin in there at all or not.

Hope this helps.

Cheers.
Kumar
_________________
IBM Certified WebSphere MQ V5.3 Developer
IBM Certified WebSphere MQ V5.3 Solution Designer
IBM Certified WebSphere MQ V5.3 System Administrator
Back to top
View user's profile Send private message Send e-mail Visit poster's website
LuisFer
PostPosted: Mon Feb 03, 2003 8:46 am    Post subject: Reply with quote

Partisan

Joined: 17 Aug 2002
Posts: 302
Thank's a lot Kumar. I compiled the Message exit ok. The problem was rrunning the NMLDEXES macro with the new MQSRLLIBjavascript:emoticon('') & the Channel Exit works without problems Thanks, thanks, thanks.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic  Reply to topic Page 1 of 1

MQSeries.net Forum Index » IBM MQ Installation/Configuration Support » Installing Exits Channel on NSK.
Jump to:  



You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
Protected by Anti-Spam ACP
  
 


Theme by Dustin Baccetti
Powered by phpBB © 2001, 2002 phpBB Group

Copyright © MQSeries.net. All rights reserved.