| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| Seq Num error |
« View previous topic :: View next topic » |
| Author |
Message
|
| ranjan1247 |
 Posted: Wed Feb 18, 2015 4:54 am Post subject: Seq Num error |
 |
|
Novice
Joined: 17 Feb 2014
Posts: 20
|
Channel is retrying and i can see error log that AMQ9526.I could see 15 msgs are there and the xmitq status uncomited(YES).
Question is if i will reset the the channel will it be work?
and wat will happen to the uncommited messages? |
|
| Back to top |
|
 |
| exerk |
| Posted: Wed Feb 18, 2015 5:59 am Post subject: |
|
|
Jedi Council
Joined: 02 Nov 2006
Posts: 6339
|
The Knowledge Centre (KC) contains all the necessary information you need to resolve your issue, but I advise you to read it very carefully...
...and when these sort of situations occur it's a two-ended resolution, i.e. you need to coordinate with the 'owners' of the 'other' end of the channel.
_________________
It's puzzling, I don't think I've ever seen anything quite like this before...and it's hard to soar like an eagle when you're surrounded by turkeys. |
|
| Back to top |
|
|
| PaulClarke |
| Posted: Wed Feb 18, 2015 6:51 am Post subject: |
|
|
Grand Master
Joined: 17 Nov 2005
Posts: 1002
Location: New Zealand
|
Ranjan,
If you get a sequence number error on a channel it is an indication that something is wrong and it should not happen in 'normal' conditions. However, it can be as trivial as someone deleting and redefining a channel, issuing the wrong reset channel command or even re-creating their Queue Manager. These can be safely ignored. But it could indicate a real problem such as ...you are sending these messages to a different QM than you thought you were, someone has recovered the QM from a backup log etc etc
Anyway, if you have convinced yourself that the reason for the sequence failure is known and understood and you just want to get things going again then you can issue a RESET CHANNEL at the sender end and all should be well...no need to update the receiver side. Any messages in prepared state on the transmission queue should be resolved correctly automatically.
Cheers,
Paul.
_________________
Paul Clarke
MQGem Software
www.mqgem.com |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
