| Author |
Message
|
| drj003 |
 Posted: Thu Aug 07, 2014 8:03 am Post subject: Send a reset sequence number request message? |
 |
|
Newbie
Joined: 07 Aug 2014
Posts: 2
|
| Is it possible to send a message that instructs the receiving customer to reset their sequence number? |
|
| Back to top |
|
 |
| mqjeff |
| Posted: Thu Aug 07, 2014 8:11 am Post subject: |
|
|
Grand Master
Joined: 25 Jun 2008
Posts: 17447
|
How would it get there, if the channel is down?
What happens when you reset the sequence of a sender channel? |
|
| Back to top |
|
|
| drj003 |
| Posted: Thu Aug 07, 2014 8:33 am Post subject: |
|
|
Newbie
Joined: 07 Aug 2014
Posts: 2
|
Yes, I agree with you. If the channel was down there wouldn't be a way to send the message. The VP of our department was reading about some other messaging software that had this feature and wanted know if there was any related feature of IBM Websphere MQ.
Thanks |
|
| Back to top |
|
|
| mqjeff |
| Posted: Thu Aug 07, 2014 8:50 am Post subject: |
|
|
Grand Master
Joined: 25 Jun 2008
Posts: 17447
|
|
| Back to top |
|
|
| gbaddeley |
| Posted: Thu Aug 07, 2014 3:49 pm Post subject: |
|
|
Jedi Knight
Joined: 25 Mar 2003
Posts: 2538
Location: Melbourne, Australia
|
As the sending customer, you could reset the sequence number to 1 at your end. Or, the number given in your qmgr error logs.
_________________
Glenn |
|
| Back to top |
|
|
| PaulClarke |
| Posted: Fri Aug 08, 2014 5:59 am Post subject: |
|
|
Grand Master
Joined: 17 Nov 2005
Posts: 1002
Location: New Zealand
|
To answer this question fully I think we need to know the exact channels involved and the conditions on which the reset it required.
The vast majority of the time it should only be necessary to reset the sender end of the channel. In this case the MQ product send the reset request to the other side automatically so you don't need to independently tell receiver to also do a reset.
Cheers,
Paul.
_________________
Paul Clarke
MQGem Software
www.mqgem.com |
|
| Back to top |
|
|
|
|
