| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| User requirement of IIB in Windwos |
« View previous topic :: View next topic » |
| Author |
Message
|
| jeevan |
 Posted: Wed Aug 13, 2014 10:15 pm Post subject: User requirement of IIB in Windwos |
 |
|
Grand Master
Joined: 12 Nov 2005
Posts: 1432
|
I installed IIB in windows 7 VM. I did not create any user for MQ or broker. before installation. When installation was completed, mqm/MUSER_MQADMIN group/user were created for MQ ( which is expected). For the broker, only a group called mqbrkrs is created. when I tried to run the default configuration, it failed and when I checked the log it seems that it failed due to the permission.
When i browse, document, did not find a clear instruction for the user id for broker. I remember, ( have not used broker for a while), that in Linux or unis, we add a user with the same name and that user is added to mqm group. But in current case, a VM admin is used to install MQ, Broker (IIB)) and to run the default configuration.
my IIB is the developer version.
Thanks |
|
| Back to top |
|
 |
| mgk |
| Posted: Wed Aug 27, 2014 9:41 am Post subject: |
|
|
Padawan
Joined: 31 Jul 2003
Posts: 1642
|
There is no requirement for a specific userid on Windows, only that the userid is a member of the "mqbrkrs" group. What may have happened is that you did not log off and log on again after the install, so the installing user was not added to the mqbrkrs group properly (group membership is determined at log on in Windows).
Kind regards,
_________________
MGK
The postings I make on this site are my own and don't necessarily represent IBM's positions, strategies or opinions. |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
