MQSeries.net :: View topic

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » mqsicommand

mqsicommand

« View previous topic :: View next topic »

Author

Message

paustin_ours

Posted: Thu Apr 03, 2014 10:48 am Post subject: mqsicommand

Yatiri

Joined: 19 May 2004
Posts: 667
Location: columbus,oh

I dont seem to recall this. There is a command that can be run that would display the entire esql code of the deployed flow along with other information. Can't seem to remember. Any thoughts?

smdavies99

Posted: Thu Apr 03, 2014 11:44 am Post subject: Re: mqsicommand

Jedi Council

Joined: 10 Feb 2003
Posts: 6076
Location: Somewhere over the Rainbow this side of Never-never land.

paustin_ours wrote:

I dont seem to recall this. There is a command that can be run that would display the entire esql code of the deployed flow along with other information. Can't seem to remember. Any thoughts?

mqsireportproperties
_________________
WMQ User since 1999
MQSI/WBI/WMB/'Thingy' User since 2002
Linux user since 1995

Every time you reinvent the wheel the more square it gets (anon). If in doubt think and investigate before you ask silly questions.

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » mqsicommand

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP