MQSeries.net :: View topic

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » Message Id

Message Id

« View previous topic :: View next topic »

Author

Message

PEPERO

Posted: Sat Aug 04, 2012 8:09 am Post subject: Message Id

Disciple

Joined: 30 May 2011
Posts: 177

Hi;
i've used an MQ header node with the "Add header" attribute's set and the MQMI_NONE and the MQCI_NONE also for the Message identifire and the correlation identifire. The message is put into the MQOutput with a new message identifire generated but how could i access the generated message identifire through the out terminal within the output message tree's MQMD header . I've used a trace node just after the MQoutput node and it shows a low-value for the Message id.

fjb_saper

Posted: Sat Aug 04, 2012 2:48 pm Post subject:

Grand High Poobah

Joined: 18 Nov 2003
Posts: 20756
Location: LI,NY

The new message id / correlation id does not get written to the MQMD. It gets written to the Local Environment tree. Look it up.

_________________
MQ & Broker admin

PEPERO

Posted: Sun Aug 05, 2012 12:17 pm Post subject:

Disciple

Joined: 30 May 2011
Posts: 177

great. that was as you've said. thanks

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » Message Id

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP