Author |
Message
|
ipujals |
Posted: Mon Jul 09, 2012 8:00 am Post subject: Payload in record&replay not shown |
|
|
Apprentice
Joined: 26 Jun 2012 Posts: 31
|
|
Back to top |
|
 |
mqjeff |
Posted: Mon Jul 09, 2012 8:30 am Post subject: |
|
|
Grand Master
Joined: 25 Jun 2008 Posts: 17447
|
There are some bugs based on the input node used. |
|
Back to top |
|
 |
pmasters |
Posted: Tue Jul 10, 2012 1:01 am Post subject: Record-replay |
|
|
Novice
Joined: 19 Jul 2011 Posts: 14
|
Hi,
At the moment, Message Broker has a limitation in the nodes that can produce a monitoring bitstream. Have a look here to see if this affects you:
http://publib.boulder.ibm.com/infocenter/wmbhelp/v8r0m0/topic/com.ibm.etools.mft.doc/ac60386_.htm
The event shows a route-to-label, so its a bit hard to tell where it is originating from the screenshot.
We're definitely looking to close the limitation here, and we'll update you when thats available.
One other point - Record-Replay does not currently use information captured in the "Event Payload" xpath section. The only exception to that is in fact "$ExceptionList".
Hope that helps,
Peter |
|
Back to top |
|
 |
ipujals |
Posted: Tue Jul 10, 2012 3:06 am Post subject: |
|
|
Apprentice
Joined: 26 Jun 2012 Posts: 31
|
Ouch!
That was my problem!! I was using a SOAPInput node. Changing it for HTTPInput, is working correctly.
Thank you very much Peter! |
|
Back to top |
|
 |
pmasters |
Posted: Tue Jul 10, 2012 3:41 am Post subject: Welcome :) |
|
|
Novice
Joined: 19 Jul 2011 Posts: 14
|
|
Back to top |
|
 |
ipujals |
Posted: Wed Jul 18, 2012 3:26 am Post subject: Re: Record-replay |
|
|
Apprentice
Joined: 26 Jun 2012 Posts: 31
|
Hi again peter,
is any plan to implement the "Event-payload" section in record-replay? Would be so useful!
pmasters wrote: |
One other point - Record-Replay does not currently use information captured in the "Event Payload" xpath section. The only exception to that is in fact "$ExceptionList".
|
Thank you very much! |
|
Back to top |
|
 |
|