| Author |
Message
|
| anilchauhanmanu |
 Posted: Wed Jul 27, 2011 2:49 am Post subject: distribution communication not working |
 |
|
Newbie
Joined: 26 Jul 2011
Posts: 9
|
distribution communication not working using remote queue .
transmission queue is full and get is disabled .
channels also not working |
|
| Back to top |
|
 |
| Mr Butcher |
| Posted: Wed Jul 27, 2011 3:09 am Post subject: |
|
|
Padawan
Joined: 23 May 2005
Posts: 1716
|
great. and what is your question?
_________________
Regards, Butcher |
|
| Back to top |
|
|
| exerk |
| Posted: Wed Jul 27, 2011 3:09 am Post subject: Re: distribution communication not working |
|
|
Jedi Council
Joined: 02 Nov 2006
Posts: 6339
|
| anilchauhanmanu wrote: |
| distribution communication not working using remote queue . |
1. See 2. below;
| anilchauhanmanu wrote: |
| transmission queue is full and get is disabled . |
2. See 3. below;
| anilchauhanmanu wrote: |
| channels also not working |
3. See 2. above.
And the purpose of your three statements is what? What have you done to fault-diagnose? Are you even aware of the conditions that will cause 1., 2., and 3. above?
_________________
It's puzzling, I don't think I've ever seen anything quite like this before...and it's hard to soar like an eagle when you're surrounded by turkeys. |
|
| Back to top |
|
|
| anilchauhanmanu |
| Posted: Wed Jul 27, 2011 3:14 am Post subject: |
|
|
Newbie
Joined: 26 Jul 2011
Posts: 9
|
| receiver channels not up and not started .and also not able to start |
|
| Back to top |
|
|
| exerk |
| Posted: Wed Jul 27, 2011 3:17 am Post subject: |
|
|
Jedi Council
Joined: 02 Nov 2006
Posts: 6339
|
| anilchauhanmanu wrote: |
| receiver channels not up and not started .and also not able to start |
RCVRs where? I refer you to my previous post, especially the last question asked.
_________________
It's puzzling, I don't think I've ever seen anything quite like this before...and it's hard to soar like an eagle when you're surrounded by turkeys. |
|
| Back to top |
|
|
| bruce2359 |
| Posted: Wed Jul 27, 2011 6:45 am Post subject: |
|
|
Poobah
Joined: 05 Jan 2008
Posts: 9469
Location: US: west coast, almost. Otherwise, enroute.
|
An xmit queue get-inhibited with messages in it is normal behavior for a stopped channel. I'm guessing (since you provided no factual information) that the channel went into error retry, and then stopped after the specified number of retries.
So, a few questions for you:
1) Has this channel pair ever worked before?
2) Did you perform an MQ PING from the non-started sender end of the channel? What were the results?
3) Did you look at the error files (logs) at both ends of the channel for symptom/error messages?
_________________
I like deadlines. I like to wave as they pass by.
ב''ה
Lex Orandi, Lex Credendi, Lex Vivendi. As we Worship, So we Believe, So we Live. |
|
| Back to top |
|
|
|
|
