| Author |
Message
|
| kumar.shanj |
 Posted: Wed Dec 08, 2010 7:58 am Post subject: Creating a EDIFACT message set |
 |
|
Apprentice
Joined: 18 Nov 2010
Posts: 49
|
I am trying to create EDIFACT message set and trying to set values to the attributes of that message set.
I am getting an error saying "5456 : Element is based on a list type. The TDS format does not support list types".
Can i find any link where i can get steps to create EDIFACT message set??? |
|
| Back to top |
|
 |
| zpat |
| Posted: Wed Dec 08, 2010 8:28 am Post subject: |
|
|
Jedi Council
Joined: 19 May 2001
Posts: 5866
Location: UK
|
You can buy the message set from IBM.
Or check out the WMB samples where an example is shown. |
|
| Back to top |
|
|
| kumar.shanj |
| Posted: Wed Dec 08, 2010 8:54 am Post subject: |
|
|
Apprentice
Joined: 18 Nov 2010
Posts: 49
|
| i want to create EDIFACT message set from scratch. I need any guide to create EDIFACT message set??? Thanks |
|
| Back to top |
|
|
| smdavies99 |
| Posted: Wed Dec 08, 2010 9:27 am Post subject: |
|
|
Jedi Council
Joined: 10 Feb 2003
Posts: 6076
Location: Somewhere over the Rainbow this side of Never-never land.
|
| kumar.shanj wrote: |
| i want to create EDIFACT message set from scratch. I need any guide to create EDIFACT message set??? Thanks |
Simply, why?
Any message set like this is going to be complex and very time consuming to create by hand.
Then of course, how do you know you are really following the standard correctly?
So you start using your hand crafted one. Whe happens when the other end starts sending messages in a way you had not envisaged. Then they say, we are using a standard edifact message. We got our xsd (etc) from IBM.
Oppsss...... I'll leave the rest for you to figure out.
I think the last line of my sig just abouyt sums it up.
_________________
WMQ User since 1999
MQSI/WBI/WMB/'Thingy' User since 2002
Linux user since 1995
Every time you reinvent the wheel the more square it gets (anon). If in doubt think and investigate before you ask silly questions. |
|
| Back to top |
|
|
| zpat |
| Posted: Wed Dec 08, 2010 2:32 pm Post subject: |
|
|
Jedi Council
Joined: 19 May 2001
Posts: 5866
Location: UK
|
| IBM give you a sample, if you don't know how to access the samples, then I would suggest you are not ready to create a complex message set. |
|
| Back to top |
|
|
|
|
