Posted: Wed Sep 18, 2002 9:18 am Post subject: Channel MSGEXIT() parameter not showing up once running exit
Novice
Joined: 09 Mar 2002 Posts: 13
Hi everyone,
I have a very strange problem here. I have a sender receiver channel combo running from NT to AIX. I have put in a message exit at the receiver end of the channel (on AIX). Now once I start up the channels, the then have a look at the receiver channel properties. I am not able to view the MSGEXIT() parameters. I tried to view this using MQExplorer and there the fields for Message exit, send/receive exit are all disabled. But the fields for the security exit are ok (enabled). Similar case when I run with 'runmqsc'. The exit is working in the channel anyway while it is running and there is no problem, but i am not able to view it or change it later without deleting the receiver end of the channel.
Has anyone come across this problem before? Any ideas?
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum