MQSeries.net :: View topic

scar · Posted: Fri Apr 30, 2010 4:42 am Post subject:

ENV : AIX 5.3 TL05
MQ : 6.2.0.3
DB2 : 9.1 FP1
Broker : 6.0.0.3

$ mqsicreatebroker BROKER -i mqsiuid -a pswd -q BROKER.QMGR -n MQSIBKDB -u "" -p ""

Enter password for database userid
Retype password for database userid
AMQ8110: WebSphere MQ queue manager already exists.
WebSphere MQ queue manager running.
The setmqaut command completed successfully.
The setmqaut command completed successfully.
The setmqaut command completed successfully.
The setmqaut command completed successfully.
The setmqaut command completed successfully.
The setmqaut command completed successfully.
The setmqaut command completed successfully.
The setmqaut command completed successfully.
The setmqaut command completed successfully.
The setmqaut command completed successfully.
The setmqaut command completed successfully.
The setmqaut command completed successfully.
The setmqaut command completed successfully.
The setmqaut command completed successfully.
The setmqaut command completed successfully.
BIP2321E: Database error: ODBC return code '-1'.
The message broker encountered an error whilst executing a database operation. The ODBC return code was '-1'. See the following messages for information obtained from the database pertaining to this error.
Use the following messages to determine the cause of the error. This is likely to be such things as incorrect datasource or table names. Then correct either the database or message broker configuration.
BIP2322E: Database error: SQL State ''82''; Native Error Code '0'; Error Text ''523 80''.
The error has the following diagnostic information: SQL State ''82'' SQL Native Error Code '0' SQL Error Text ''523 80''
This message may be accompanied by other messages describing the effect on the message broker itself. Use the reason identified in this message with the accompanying messages to determine the cause of the error.

BIP8040E: Unable to connect to the database.
The database cannot be accessed with the userid and password that were specified when the broker was created.
Check that the database is running, that an ODBC connection has been created and that the userid and password pair specified for ODBC connect on the mqsicreate command are capable of being used to connect to the database using an ODBC connection. Also ensure that the database has a adequate number of database connections available for use.

I can connect to the database as mqsiuid with out any problems.

I am not sure whats going on. any help is appreciated.