MQSeries.net :: View topic

rajparekh08 · Posted: Fri Nov 06, 2009 4:44 am Post subject:

HI,
The HttpListener is running.
The port no is configured.
But I am unable to put a message, with an error- could not connect.
and also, when i issued the following command, look at the response i got:

mqsireportproperties WSSDPR61 -b httplistener -o HTTPlistener -a

Response:
BIP2051E: Broker WSSDPR61 (UUID 68f60d53-2401-0000-0080-886fba9aa7a0) could not process an internal configuration message to completion, the problem was caused by 'httplistener'.
The configuration message could not be processed and was rejected.
Use the inserts within this message to determine the cause of the problem. Correct the broker's configuration and redeploy using the Message Brokers Toolkit, mqsideploy command or Config Manager Proxy application. Contact your IBM support center if you are unable to resolve the problem.
BIP2087E: Broker WSSDPR61 was unable to process the internal configuration message.
The entire internal configuration message failed to be processed successfully.
Use the messages following this message to determine the reasons for the failure. If the problem cannot be resolved after reviewing these messages, contact your IBM Support center. Enabling service trace may help determine the cause of the failure.
BIP2051E: Broker WSSDPR61 (UUID 68f60d53-2401-0000-0080-886fba9aa7a0) could not process an internal configuration message to completion, the problem was caused by 'Report : HTTPlistener'.
The configuration message could not be processed and was rejected.
Use the inserts within this message to determine the cause of the problem. Correct the broker's configuration and redeploy using the Message Brokers Toolkit, mqsideploy command or Config Manager Proxy application. Contact your IBM support center if you are unable to resolve the problem.
How do I resolve this??