ASG
IBM
Zystems
Cressida
Icon
Netflexity
 
  MQSeries.net
Search  Search       Tech Exchange      Education      Certifications      Library      Info Center      SupportPacs      LinkedIn  Search  Search                                                                   FAQ  FAQ   Usergroups  Usergroups
 
Register  ::  Log in Log in to check your private messages
 
RSS Feed - WebSphere MQ Support RSS Feed - Message Broker Support

MQSeries.net Forum Index » General IBM MQ Support » need to know bit about channel status...

Post new topic  Reply to topic
 need to know bit about channel status... « View previous topic :: View next topic » 
Author Message
mqvasu
PostPosted: Thu Aug 29, 2002 9:10 pm    Post subject: need to know bit about channel status... Reply with quote

Newbie

Joined: 16 May 2002
Posts: 8
Hi All,

When I use the command DISPLAY CHSTATUS(*), I was getting the sender channel status of both myside as well as the destinatin channel status.

But when tried to check the status now using the above command I get only the status of my sender channel and not that of the destination channel. The channels are also up as I am getting both COA and COD.

Is there any option through which I can hide the destination channel status being displayed.

Do suggest me.

regards,
Vasu
Back to top
View user's profile Send private message
kingsley
PostPosted: Thu Aug 29, 2002 10:12 pm    Post subject: Reply with quote

Disciple

Joined: 30 Sep 2001
Posts: 175
Location: Hursley
The Only thing you need to keep in mind is

dis chs(*), if the sender side is in running state, then everything is ok.

If the channel is in retrying or starting state or stopped state , then you need to check the error logs and take the required decision.

Ping channel will tell you whether the listener on the other side is active or not even though the channel is not in running state.

Not necessary to check receiver side every time.

If the channel is in retrying state, just keep an eye on Sequece Number which should match on both the sides. If they are not matching then reset the seq num on both sides of the channel and restart them.
Back to top
View user's profile Send private message Visit poster's website
Display posts from previous:   
Post new topic  Reply to topic Page 1 of 1

MQSeries.net Forum Index » General IBM MQ Support » need to know bit about channel status...
Jump to:  



You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
Protected by Anti-Spam ACP
  
 


Theme by Dustin Baccetti
Powered by phpBB © 2001, 2002 phpBB Group

Copyright © MQSeries.net. All rights reserved.