MQSeries.net :: View topic

aditya.aggarwal · Posted: Thu Jun 25, 2009 9:00 pm Post subject:

Hi,

I am developing a WBIMB V6 message flow to genrate three different reply format i.e. CWF1, TDS and XML for a input xml message.

Whenver i put the xml input message using RFH2 util it always come back in to the failure node of input queue. I am specifying the REPLY TO queue name in MQMD of RFH2 util but when i browse the message in the failure queue it shows the blan filed for the reply to queue name.

When i trace the message flow i have seen the below error in trace file:

ParserException BIP5313E: Message format ''CWF1'' is not defined for message set ''COMPLAINT_MSGSET (ADLDI48002001)''.
The broker received a message for processing within the MRM domain.
However, the message cannot be processed because the message format specified in the physical format identifier ''CWF1'' has not been defined for message set ''COMPLAINT_MSGSET (ADLDI48002001)''.
The message format describes the physical representation of the message, and you can specify this format either in the properties on an input node, or dynamically within an MQRFH2 message header.
If the physical format identifier was intended to identify a message format, take one or more of the following actions:
1) Check that the message format has been specified correctly on the MQInput node, or within the MQRFH2 header.
2) Check that the correct message set has been specified on the MQInput node, or within the MQRFH2 header
3) Add the appropriate physical format information to your message set, and redeploy your message set.
4) Ensure that your message set has been correctly deployed.

Can anyone advise how to resolve this issue?

Cheers,
Aditya