Posted: Mon Jun 22, 2009 6:54 am Post subject: RFH vs Normal message
Novice
Joined: 25 May 2009 Posts: 19
There is a input queue . Queue.Input
I try to test the message flow (beginning with MQInput) against 2 messages.
(1). Message with NO RFH header set on the RFH tab of RFHUTILC .
(2). Message with appropriate RFH header set on the RFH tab of RFHUTILC .
I am facing the following issue
When I put Msg (1), followed by Msg (2).. both of them get picked up. BUT if I put, Msg (1) again.. it does not get picked up.
Msg (1) then Msg(2) works. If I again put Msg(1) ---> does not work
Also
Msg (2) then Msg(1) works. If I again put Msg(2) --> does not work.
also,
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum