MQSeries.net :: View topic

sireesha · Posted: Thu Aug 02, 2007 4:19 am Post subject: mqsichangeproperties

Hi,

I am using MBV5.0.5
I am trying to change the properties of default broker WBRK_BROKER

I issued the below command

mqsichangeproperties WBRK_BROKER -e default -o ComIbmSocketConnectionManager -n tcpNoDelay -v true

I am getting the below error

BIP2087E: Broker WBRK_BROKER was unable to process the internal configuration message.
The entire internal configuration message failed to be processed successfully.
The internal configuration message failed to be processed, use the messages following this message to determine the reasons for the failure.
BIP4041E: Execution group 'default' received an invalid configuration message. See the following messages for details of the error.
The message broker received an invalid configuration message and has not updated its configuration. This can arise as a result of errors in the specification of either message flows or message sets which the configuration manager was unable to detect. It can also result from a message flow requiring a type of node that is not supported by the broker installation, from the broker having become out of step with the configuration database or from other applications sending extraneous messages to the broker's configuration queues (SYSTEM.BROKER.ADMIN.QUEUE & SYSTEM.BROKER.EXECUTIONGROUP.QUEUE).
Check the relevant message flow and message set definitions, check that all necessary plug-ins are installed, perform a complete redeploy of the broker's configuration and ensure that no applications are writing to the broker's configuration queues.
BIP2212E: Invalid configuration message containing action 'Change' which is not valid for target object 'ComIbmResourceManager'.
The message broker received a configuration message containing the action 'Change' which is not valid for the target object 'ComIbmResourceManager'. This can be caused by a mismatch in levels between the Message Brokers Toolkit, the Configuration Manager and the Broker, or as a result of a user or third party written plug-in node where the implementation library installed at the broker does not match the node definition held at the Configuration manager and Message Brokers Toolkit.
Ensure that the levels of code installed at the Message Brokers Toolkit, Configuration Manager and Broker are all consistent. If they are, identify the supplier of the target object and report the problem to them. If this is IBM, contact your IBM support center.

BIP8036E: Negative response received.
This command sends an internal configuration message to the broker, the response received indicated that the internal configuration message was unsuccessful.
Check that the WebSphere Business Integration transport is available. Check the system log for further information.

Can anyone help for that?

Thanks,
Sireesha