MQSeries.net :: View topic - Conditional to check 2 values in the mapping editor?

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » Conditional to check 2 values in the mapping editor?

Conditional to check 2 values in the mapping editor?

« View previous topic :: View next topic »

Author

Message

Posted: Tue Feb 10, 2009 2:26 am Post subject: Conditional to check 2 values in the mapping editor?

Master

Joined: 31 May 2007
Posts: 254
Location: Sweden

Hi,

I'm trying to configure an if statement to check two source values. This looks like a no-brainer but is it even possible to do something like this?

Code:

$source/tns1:root/tns1:value1 eq "new" AND $source/tns1:root/tns1:value2 eq "approved"

I've tried various combinations of parenthesis and different operators AND/&& etc but no success.

MQEnthu

Posted: Tue Feb 10, 2009 3:20 am Post subject:

Partisan

Joined: 06 Oct 2008
Posts: 329
Location: India

conditional operators 'and' and 'or'. Please note that these are case sensitive. Also the assignment operator for equals is '='
_________________
-----------------------------------------------
It is good to remember the past,
but don't let past capture your future

Posted: Tue Feb 10, 2009 5:20 am Post subject:

Master

Joined: 31 May 2007
Posts: 254
Location: Sweden

Thanks a lot, I'd missed the case sensitivity

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » Conditional to check 2 values in the mapping editor?

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP