MQSeries.net :: View topic - How can I trace the mqsichangeproperties command?

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » General IBM MQ Support » How can I trace the mqsichangeproperties command?

How can I trace the mqsichangeproperties command?

« View previous topic :: View next topic »

Author

Message

rmah

Posted: Fri Aug 01, 2008 4:00 pm Post subject: How can I trace the mqsichangeproperties command?

Centurion

Joined: 04 May 2007
Posts: 142

Hi all,

I'm trying to clone brokers, but the brokers refuse to be cloned. I'd like to run a trace against the mqsichangeproperties command - how do I do this? mqsichangeproperties is not a valid qualifier...

Thanks!

_________________
MQ 6.0.2.3
Broker 6.0.0.7
for Linux

sami.stormrage

Posted: Tue Aug 05, 2008 11:52 am Post subject:

Disciple

Joined: 25 Jun 2008
Posts: 186
Location: Bangalore/Singapore

run a trace on the broker.. on 5.3 it was under /tmp/broker.trace.. dint find it in the same path in 6.0.. refer boker adminstartion guide also.
_________________
*forgetting everything

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » General IBM MQ Support » How can I trace the mqsichangeproperties command?

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP