MQSeries.net :: View topic - Can I convert the message set properties...!

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » Can I convert the message set properties...!

Can I convert the message set properties...!

« View previous topic :: View next topic »

Author

Message

DIPU@2007

Posted: Wed Dec 26, 2007 1:41 am Post subject: Can I convert the message set properties...!

Novice

Joined: 13 Dec 2007
Posts: 18

I have a flow, which accepts a message from certain source, for which already the message set is defined, I wish to change this message set for further processing compatible to my flow,with my message set....

Can this be possible....

if i am trying to use a Reset Content Descriptor also, I get RM Dictionary not found and message is routed to failure terminal.

Could any one help out...???

smdavies99

Posted: Wed Dec 26, 2007 3:11 am Post subject: It seems to me that

Jedi Council

Joined: 10 Feb 2003
Posts: 6076
Location: Somewhere over the Rainbow this side of Never-never land.

the error message "RM Dictionary Not Found" describes it all.

If you are using messages sets like this you need to BOTH the INPUT & OUTPUT Messages sets deployed to the execution group where the flow is running.

The "RM..." message indicates that the destination message set is not available for the broker to use in that particular EG.

One common reason for this is not specifying the message set definitions correctly in the RCD node. There have been a number of posts on this forum over the years where the poster says "but the message set is deployed"
This can be solved easily by adding the Message Set Project to the list of projects referenced by the Flow itself. Then the available message sets will appear in the drop down list of sets in the RCD properties. A little tip to get this list populated is to initially change the message domain to MRM, get all the properties filled in and then switch the domain back to the one you want to use such as XMLNSC etc (unless you want to use the MRM domain that is)

Later versions of the Toolkit (6.0.2, 6.1 etc) will actually produce warning messages if the above tip is not followed so it sor of make sense to do it anyway.
_________________
WMQ User since 1999
MQSI/WBI/WMB/'Thingy' User since 2002
Linux user since 1995

Every time you reinvent the wheel the more square it gets (anon). If in doubt think and investigate before you ask silly questions.

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » Can I convert the message set properties...!

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP