| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| Asking a question about MQ channel |
« View previous topic :: View next topic » |
| Author |
Message
|
| Bni |
 Posted: Tue Jul 10, 2007 8:58 am Post subject: Asking a question about MQ channel |
 |
|
Apprentice
Joined: 09 Aug 2006
Posts: 29
|
I have created a sender channel in mq connecting to a remote mq server(it is a exact copy of the existing sender channel in production environment). We are not sending anything right now, I can start it and it is in running mode, but after a while(hours maybe), it will become inactive state. Is that sender channel supposed to in running mode all the time? or it is becase we don't have any traffic, so it becomes inactive, and when trafffic resumes, it will become running mode again?
Thank you very much. |
|
| Back to top |
|
 |
| Bni |
| Posted: Tue Jul 10, 2007 9:24 am Post subject: I found out a disconnect interval |
|
|
Apprentice
Joined: 09 Aug 2006
Posts: 29
|
Is this parameter control the timeout if there are no traffic? currently it is being set to 6000.
Thank you |
|
| Back to top |
|
|
| RogerLacroix |
| Posted: Tue Jul 10, 2007 9:51 am Post subject: |
|
|
Jedi Knight
Joined: 15 May 2001
Posts: 3264
Location: London, ON Canada
|
Hi,
Read the WMQ Intercommunication manual as all is explained in the manual.
Regards,
Roger Lacroix
Capitalware Inc.
_________________
Capitalware: Transforming tomorrow into today.
Connected to MQ!
Twitter |
|
| Back to top |
|
|
| Bni |
| Posted: Tue Jul 10, 2007 10:04 am Post subject: |
|
|
Apprentice
Joined: 09 Aug 2006
Posts: 29
|
| Thank you very much, I know the answer from your suggestion by going to the online manuel. |
|
| Back to top |
|
|
| kevinf2349 |
| Posted: Tue Jul 10, 2007 11:03 am Post subject: |
|
|
Grand Master
Joined: 28 Feb 2003
Posts: 1311
Location: USA
|
| Quote: |
, so it becomes inactive, and when trafffic resumes, it will become running mode again?
|
If the XMITQ is triggered it will...otherwise...nope.
But before you knee jerk at setting the disconnect interval to 0 understand the implications of doing so. Seriously consider triggering the channels if the demands of the business allow it. |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
