| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| Flow Deployment Issue |
« View previous topic :: View next topic » |
| Author |
Message
|
| mymq |
 Posted: Wed May 23, 2007 8:42 pm Post subject: Flow Deployment Issue |
 |
|
Centurion
Joined: 01 Mar 2007
Posts: 101
Location: US-Greenwille
|
Hi,
In my DEV environment, we are facing an issue related with DEPLOYMENT. When i look at the syslog.log, it says that the DEPLOYMENT is in progress. But it does not allow us to deploy us. It keeps saying the same.
This is the case, what do we do normally?
1) I tried to Cancel the deployment
2) Stop/Start the Broker/Config mgr
But i dont see any progress on it.
3) Should i go ahead and delete the respective entry from the CBROKER table? is this right approach to do so?
Anyone can help me out?
_________________
--SRK-- |
|
| Back to top |
|
 |
| smdavies99 |
| Posted: Wed May 23, 2007 10:40 pm Post subject: Have you tried to find out WHY the deploy didn't complete? |
|
|
Jedi Council
Joined: 10 Feb 2003
Posts: 6076
Location: Somewhere over the Rainbow this side of Never-never land.
|
There are several/many posts here that describe 'fixing' the CBROKER table and yes many people do that. However, unless you have found out the reason why the failed in the first place you may very well end up back where you started.
- One very common cause of this is the MQ channels to/from the Broker are not setup properly and don't autostart when a message arrives on the channel xmit q.
- Another point to look at, is the problem just confined to this broker? Does the flow depoy to other brokers?
- Are you using any additional nodes eg Sendmail
- What do any relevant messages in the system log(s) say?
- Are all the relevant databases properly configured (more of a runtime issue but worth a check)
- Finally, what version of Broker are you using including fixpack levels, plus what platform are you using.
_________________
WMQ User since 1999
MQSI/WBI/WMB/'Thingy' User since 2002
Linux user since 1995
Every time you reinvent the wheel the more square it gets (anon). If in doubt think and investigate before you ask silly questions. |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
