MQSeries.net :: View topic

bijesh · Posted: Thu Apr 12, 2007 8:21 pm Post subject: BIP2266W

Hi all,

I'm getting errors while deploying.
The erros are given below. I've searched for the same in this forum and I got a post which says to remove the reference and deploy again. Does that solve the issue and how can I get rid of this error?

Please find the erros i got while deploying the flow.

BIP2266W: Request to change attribute in message flow node '27890c8e-1101-0000-0080-8ee1a27e5615': message flow does not exist.

The message broker received a configuration message containing an instruction to change an attribute in the message flow node '27890c8e-1101-0000-0080-8ee1a27e5615' but this message flow does not exist.

Redeploy the new configuration to the broker ensuring that the complete configuration option is used. If the problem persists contact your IBM support center.

BIP4041E: Execution group 'WMQDQM01_EG01' received an invalid configuration message. See the following messages for details of the error.

The message broker received an invalid configuration message and has not updated its configuration. This can arise as a result of errors in the specification of either message flows or message sets which the configuration manager was unable to detect. It can also result from a message flow requiring a type of node that is not supported by the broker installation, from the broker having become out of step with the configuration database or from other applications sending extraneous messages to the broker's configuration queues (SYSTEM.BROKER.ADMIN.QUEUE & SYSTEM.BROKER.EXECUTIONGROUP.QUEUE).

Check the relevant message flow and message set definitions, check that all necessary user-defined extensions are installed, perform a complete redeploy of the broker's configuration and ensure that no applications are writing to the broker's configuration queues.

BIP2087E: Broker WMQDQM01_BK was unable to process the internal configuration message.

The entire internal configuration message failed to be processed successfully.

The internal configuration message failed to be processed, use the messages following this message to determine the reasons for the failure.

Any thoughts to share on this?