MQSeries.net :: View topic - WMB 6.0 and DB2 8.2

MQSeries.net

Tech Exchange

Education

Certifications

Library

Info Center

SupportPacs

FAQÂ Â

Usergroups

RSS Feed - WebSphere MQ Support

RSS Feed - Message Broker Support

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » WMB 6.0 and DB2 8.2

WMB 6.0 and DB2 8.2

« View previous topic :: View next topic »

Author

Message

KoGor

Posted: Fri Mar 02, 2007 10:05 am Post subject: WMB 6.0 and DB2 8.2

Voyager

Joined: 09 Nov 2005
Posts: 81
Location: Moscow,Russia.

Hi ALL!

I can't understand if it's possible to use Message Broker have installed on one LPAR (AIX) and DB2 have installed on another LPAR (AIX). They are connected by Virtual Ethernet adapters. Is this configuration valid or I must put DB2 on the same LPAR where WMB located? If I can use this configuration with two LPAR what DB2 components should I install on LPAR with WMB?

Thank you in advance!

jefflowrey

Posted: Mon Mar 05, 2007 7:20 pm Post subject:

Grand Poobah

Joined: 16 Oct 2002
Posts: 19981

It's no different than running a remote DB2.
_________________
I am *not* the model of the modern major general.

Display posts from previous:

Page 1 of 1

MQSeries.net Forum Index » WebSphere Message Broker (ACE) Support » WMB 6.0 and DB2 8.2

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Protected by Anti-Spam ACP