| Author |
Message
|
| venusboy |
 Posted: Wed Nov 29, 2006 9:18 pm Post subject: Creating an XML attribute for a xsd:AnyType using MRM |
 |
|
Acolyte
Joined: 11 Jun 2002
Posts: 51
|
I have a XML schema that I need to model as an MRM for validation purposes. This schema contains a xsd:AnyType type, for example:
<xs:element name="FixedType" type="xs:string">
<xs:element name="AnyType" type="xs:anyType"/>
Thus the following XML is valid against the Schema extract:
<FixedType>myString</FixedType>
<AnyType undefinedAttribute="67890">
<UndefinedElement>12345</UndefinedElement>
</AnyType>
The question is how can I model the attribute when it's defined as an anyType MRM? The MRM defines the xs:anyType as:
a) Wildcard Attribute *
b) Wildcard Element *
Which is fine for incoming messages, but I need to construct the example above.
Can this be done in one swoop. Reading other posts, then I understand the (XML.Attr) will compile and deploy but has no effect on the MRM as normally the XML type would be defined in the set.
Thanks in advance. |
|
| Back to top |
|
 |
| kimbert |
| Posted: Thu Nov 30, 2006 1:22 am Post subject: |
|
|
Jedi Council
Joined: 29 Jul 2003
Posts: 5542
Location: Southampton
|
| Have you tried importing your schema? |
|
| Back to top |
|
|
| venusboy |
| Posted: Mon Dec 04, 2006 9:24 pm Post subject: |
|
|
Acolyte
Joined: 11 Jun 2002
Posts: 51
|
Thanks for the response and not getting back to you earlier.
Yes that's the point am using an MRM that is has been generated by importing my XSD. But I cannot tell the MRM to use an attribute as it element is in-effect a wildcard. |
|
| Back to top |
|
|
| kimbert |
| Posted: Tue Dec 05, 2006 1:58 am Post subject: |
|
|
Jedi Council
Joined: 29 Jul 2003
Posts: 5542
Location: Southampton
|
Try
| Code: |
| CREATE FIRSTCHILD OF anyType Name '@undefinedAttribute' TYPE NameValue VALUE '67890'; |
|
|
| Back to top |
|
|
| shanson |
| Posted: Tue Dec 05, 2006 4:44 am Post subject: |
|
|
Partisan
Joined: 17 Oct 2003
Posts: 344
Location: IBM Hursley
|
| As an alternative, try using XMLNSC or XMLNS, and the Schema Validation supportpac IA9A (http://www-1.ibm.com/support/docview.wss?rs=171&uid=swg24010092&loc=en_US&cs=utf-8&lang=en). |
|
| Back to top |
|
|
|
|
